What is the difference between the A ...

What is the difference between additive manufacturing (AM) end mills and high hardness steel end mills? Additive manufacturing (AM) end mills are charac... 詳細表示

Ball End Mill for High Hardness Steel

OSG has a lineup of ball end mills for high hardness according to the application. OSG has a lineup of ball end mills (A end mill series) for high hardn... 詳細表示

What are the types of cutting fluid w...

What are the types of cutting fluid when using AE-LNBD-N and what should they be used properly? Basically, we recommend "water-soluble coolant". If you... 詳細表示

Is the AE-VTFE-N an end mill dedicate...

In addition to deep side milling of non-ferrous materials, the AE-VTFE-N also supports wide groove machining using trochoidal milling and hole or pocket mach... 詳細表示

AE-VTSS is described as “designed for...

Although AE-VTSS is designed for automatic lathes, it can also be used on machining centers and NC milling machines. Its short cutting length provides high ... 詳細表示

Can AE-LNBD-N be reground ?

AE-LNBD-N can be reground. (R2 and above). Recoating is also recommended to ensure performance. If you are considering recoating and regrinding, plea... 詳細表示

What is an end mill that can process ...

If there is an indication for a right-angle corner in the drawing, the end mill side must also be at a right angle. However, in the case of a typical carbide... 詳細表示

If a long flute length end mill is cu...

The long flute type AE-VML of the AE-VM series is available with a chip breaker . The cutting edge has a groove called a nick that separates the chips. A... 詳細表示

What is AE-LNBD-N?

What is AE-LNBD-N? DLC carbide end mill for copper electrode This is a 2-flute long neck ball type for high-precision finishing. It is effective in suppres... 詳細表示

Holder selection when using AE-LNBD-N

Holder selection when using AE-LNBD-N Use a rigid holder with as little runout as possible. The shank of the AE-LNNBD-N adopts a high-precision h4 tole... 詳細表示