What is an end mill that can process ...

If there is an indication for a right-angle corner in the drawing, the end mill side must also be at a right angle. However, in the case of a typical carbide... 詳細表示

When using AE-VTSS for plunge cutting...

Since this end mill has a relief angle, plunge cutting alone will not produce a flat bottom surface. However, if you follow up with lateral cutting or simil... 詳細表示

What is AE-VTSS,carbide anti-vibratio...

AE-VTSS is a carbide anti-vibration end mill designed with optimal specifications for machining on automatic lathes, featuring the following characteristics:... 詳細表示

Can AE-CPR4-H be reground? 4-flute lo...

Regrinding of AE-CPR4-H is not supported. 詳細表示

Holder selection when using AE-LNBD-N

Holder selection when using AE-LNBD-N Use a rigid holder with as little runout as possible. The shank of the AE-LNNBD-N adopts a high-precision h4 tole... 詳細表示

What is AE-MSS-H?

What is AE-MSS-H? Carbide end mill for high-hardness steel multiple flutes Square type stub type (= shorter than short type flute length = 1.5D). ▲ T... 詳細表示

Unequal lead,unequal division is,what...

For example, in a 4-flute end mill, the two adjacent peripheral flute have different helix angles ( variable lead ), and the 90° division of the end cutting ... 詳細表示

What is a high-performance DLC end mi...

What is a high-performance DLC end mill for non-ferrous metals AE-VTS-N? We will introduce in detail the end mill AE-VTS-N, which can process non-ferrous me... 詳細表示

Is there a standard cutting condition...

Our non-ferrous DLC end mills (AE-TS-N, AE-TL-N, AE-VTS-N, PXAL) are also suitable for resin machining. The types of resin listed in the cutting condition t... 詳細表示

I would like to know whether AE-VTFE-...

Regrinding is possible. To ensure performance, recoating is also recommended. If you are considering regriding or recoating, please contact the OSG sales... 詳細表示