Cutting conditions for end mills and ...
For milling and indexable tools, the following three numbers are required: (1) Revolution (min-1) How many revolutions per minute . In NC code, it is ex... 詳細表示
How to machine right-angle shapes wit...
In order to machine a right-angle shape with an end mill, the tool side that processes it must also have a right-angle shape when rotated. The shape of the t... 詳細表示
End mills with a flat end cutting edge
For end mills with a flat end cutting edge, the tool selection depends on the application. Application (1) Counterboring Machining ・ Counterboring En... 詳細表示
How to calculate cutting conditions d...
How to calculate cutting conditions during helical machining Revolution, feed rate, distance traveled in the Z-axis direction per helical lap Learn how to c... 詳細表示
Can the plunging at the end mill be e...
In a typical end mill, it is not possible to process the bottom surface flat only with plunging . The reason is that the end cutting edge is not flat. If y... 詳細表示
Whether or not HY-HSCM-P can be regri...
The regrinding of the HY-HSCM-P is possible. * The total length changes because the cutting edge is cut. 詳細表示
What is step cutting, end milling, de...
For example, in the case of deep side milling, it takes a very long overhang length to process. The long overhang makes it easier for the tool to deflect du... 詳細表示
What are the effective measures again...
The causes and countermeasures for chattering are summarized below. Chattering Fast cutting speed Reducing the revolution. Resonance Change the re... 詳細表示
This is a carbide end mill dedicated to 45° back chamfering. In general, "right-hand cut, right-hand helix" front/back tools tend to be "negative cutting"... 詳細表示
How much processing conditions should...
The greater the tool overhang relative to its diameter, the more chattering and deflection will occur during machining.By reducing the cutting conditions, th... 詳細表示
Results:39 ,Showing: 1 - 10