Is it possible to process half-hole?　...

Half-Hole is possible. However, it is necessary to adjust the cutting conditions. Reference: Processing half-hole 詳細表示

Difference Between ADO-SUS Drill and ...

Difference Between ADO-SUS Drill and ADO Drill The main difference between the two drills is the corresponding workpiece material. The ADO-SUS series is sp... 詳細表示

I bought an ADO-SUS drill 6mm, but th...

ADO-SUS drills have round oil holes up to φ6. It uses a special shape MEGA COOLER that can secure a larger amount of coolant discharge than the round type... 詳細表示

What are the coatings of the ADF series?

It is called EgiAs coating. It is a composite multilayer coating that suppresses wear with a wear-resistant layer and prevents crack propagation with nano-pe... 詳細表示

Should step machining be performed wh...

When machining stainless steel in the ADO-SUS series, non-step machining is generally recommended. This is because step machining increases contact with the... 詳細表示

Carbide Flat Drill What is ADF?

Carbide Flat Drill What is ADF? Drills that can be used on inclined and curved surfaces with high efficiency Carbide flat drills ADF / ADFO series. Th... 詳細表示

Difference Between Flat Drill and End...

The difference between a flat drill (ADF series) and an end mill for counterboring (ZDS series) is as follows: ADF can be machined to twice the depth of the... 詳細表示

Is step feeding with an ADO-SUS drill...

It is better not to step because it will be adversely affected by work hardening. When using an non-water-soluble coolant agent, Dwell processing (G04) is r... 詳細表示

How many hole depths can the ADF-2D b...

Basically, since the helix angle is low, the chip discharge is lower than that of conventional drills, so it can be processed in 2D. It is possible to proce... 詳細表示

If the rigidity of the tool is good, ...

The high stiffness of the ADF is due to the weak spiraled flute of 20 degrees. The unique groove shape and smoothing process achieve both chip discharge and... 詳細表示