When using AE-VTSS for plunge cutting...

Since this end mill has a relief angle, plunge cutting alone will not produce a flat bottom surface. However, if you follow up with lateral cutting or simil... 詳細表示

< Why does AE-VML > is it less likely...

This is because it has a web tapered specification that thickens the thickness of core from the cutting edge to the shank. It is even more rigid than convent... 詳細表示

What is AE-VTFE-N?

This is a long shank type end mill with a shape with a tool outer diameter larger than the shank diameter that is suitable for deep side milling and pocket m... 詳細表示

What is the good DUROREY coating appl...

What is the good DUROREY coating applied to end mills for high-hardness steel? The DUROREY coating consists of an ultra-heat-resistant layer containing SiC ... 詳細表示

Does AE-VTSS have a flat-bottom finis...

This end mill is not designed with a flat-bottom finishing edge. ・ What is AE-VTSS? 詳細表示

What are the types of cutting fluid w...

What are the types of cutting fluid when using AE-LNBD-N and what should they be used properly? Basically, we recommend "water-soluble coolant". If you... 詳細表示

Can AE-MS-H regrinding ?

Can AE-MS-H regrinding ? regrinding is possible. In order to ensure performance, recoating is also recommended. If you are considering recoating and... 詳細表示

If a long flute length end mill is cu...

The long flute type AE-VML of the AE-VM series is available with a chip breaker . The cutting edge has a groove called a nick that separates the chips. A... 詳細表示

Can AE-CPR4-H be reground? 4-flute lo...

Regrinding of AE-CPR4-H is not supported. 詳細表示

Can AE-VMFE be reground?

AE-VMFE can be reground. In order to ensure performance, recoating is also recommended. If you wish to regrind and recoat, please contact our sales offic... 詳細表示