Difference Between ADO-SUS Drill and ...

Difference Between ADO-SUS Drill and ADO Drill The main difference between the two drills is the corresponding workpiece material. The ADO-SUS series is sp... 詳細表示

Can the long shank specification of t...

As per the model number of ADFLS-2D, the maximum machining depth is up to 2D. The long shank specification is designed to reach distant processing areas. ... 詳細表示

How many hole depths can the ADF-2D b...

Basically, since the helix angle is low, the chip discharge is lower than that of conventional drills, so it can be processed in 2D. It is possible to proce... 詳細表示

Is step feeding with an ADO-SUS drill...

It is better not to step because it will be adversely affected by work hardening. When using an non-water-soluble coolant agent, Dwell processing (G04) is r... 詳細表示

Carbide Flat Drill What is ADF?

Carbide Flat Drill What is ADF? Drills that can be used on inclined and curved surfaces with high efficiency Carbide flat drills ADF / ADFO series. Th... 詳細表示

Is centering required before drilling...

In the ADO, ADO-SUS series, in the case of a flat surface, Alternatively, centering is not required if the processing depth is less than or equal to 8 times... 詳細表示

How many Cutting diameter to double ...

φ3 mm or more is a double margin. 詳細表示

The new normal of 3-flute drills! Wha...

The new normal of 3-flute drills! What is ADO-TRS? I want to improve my drilling process. I hear that a 3-flute drill is more difficult to use than a 2-flu... 詳細表示

ADF-2D and ADFO-3D back-taper amount ...

In order to cope with intermittent cutting, it is strong at 0.45 ~ 0.50 / 100 mm. 詳細表示

Is it possible to use non-water-solub...

Is it possible to use non-water-soluble coolant (internal coolant) in ADO-SUS drills? Compared to water-soluble coolant, the cooling effect and oil discharg... 詳細表示