Is there a general-purpose drill that...

A general-purpose drill that is carbide and can be used in external coolant supply instead of internal coolant supply is AD-2D and AD-4D are available. U... 詳細表示

ADO-SUS series and EX-SUS series. A w...

The main difference is the tool material. The ADO-SUS drill series is made of carbide and has internal coolant supply specifications. internal coolant su... 詳細表示

Can the long shank specification of t...

As per the model number of ADFLS-2D, the maximum machining depth is up to 2D. The long shank specification is designed to reach distant processing areas. ... 詳細表示

Is The ADO-SUS drill series availabl...

The ADO-SUS drill series is available in regrinding . Recoating is also recommended for better performance. However, since we also use our own cutting edge ... 詳細表示

Is centering required before drilling...

In the ADO, ADO-SUS series, in the case of a flat surface, Alternatively, centering is not required if the processing depth is less than or equal to 8 times... 詳細表示

What is the guideline for adjusting c...

When machining surfaces with an inclination angle of 30° or less, use a feed rate of 40-60% of the values in the cutting conditions reference table as a guid... 詳細表示

What is the guideline for correction ...

The standard for correcting cutting conditions in through hole machining of curved surfaces of the ADF series is as follows: To minimize burrs at the edge... 詳細表示

When to use ADO drills and ADO-SUS dr...

Mainly, ADO-SUS drills are recommended for machining stainless steel, titanium alloys. For carbon steels, alloy steels, and tempered steels up to 40 HRC, us... 詳細表示

What is the guideline for correction ...

Reduce the number of speed (min-1) to 60%. The feed per revolution (mm/rev) does not need to be changed as long as it is within the catalog range. 詳細表示

ADF-2D and ADFO-3D back-taper amount ...

In order to cope with intermittent cutting, it is strong at 0.45 ~ 0.50 / 100 mm. 詳細表示