Can I use ADO-SUS drills with drillin...

We don't recommend it. Since it is used in a high cutting conditions range, it is necessary to grip the tool with high precision and rigidity, and to hold th... 詳細表示

I want to make the tip flat with a ho...

I want to make the tip flat with a hole depth of 5D. "ADF and ADFO" After machining a 5D hole with a normal drill with a tip angle, only the tip angle is ma... 詳細表示

Measures against internal burrs in th...

Measures against internal burrs in the side hole processing of pipes "ADF and ADFO" The ADF-2D and ADFO-3D series are effective for internal burrs in the si... 詳細表示

ADF-2D and ADFO-3D back-taper amount ...

In order to cope with intermittent cutting, it is strong at 0.45 ~ 0.50 / 100 mm. 詳細表示

What is the guideline for correction ...

Reduce the number of speed (min-1) to 60%. The feed per revolution (mm/rev) does not need to be changed as long as it is within the catalog range. 詳細表示

When to use ADO drills and ADO-SUS dr...

Mainly, ADO-SUS drills are recommended for machining stainless steel, titanium alloys. For carbon steels, alloy steels, and tempered steels up to 40 HRC, us... 詳細表示

What is the guideline for correction ...

The standard for correcting cutting conditions in through hole machining of curved surfaces of the ADF series is as follows: To minimize burrs at the edge... 詳細表示

What is the guideline for adjusting c...

When machining surfaces with an inclination angle of 30° or less, use a feed rate of 40-60% of the values in the cutting conditions reference table as a guid... 詳細表示

Is centering required before drilling...

In the ADO, ADO-SUS series, in the case of a flat surface, Alternatively, centering is not required if the processing depth is less than or equal to 8 times... 詳細表示

Is The ADO-SUS drill series availabl...

The ADO-SUS drill series is available in regrinding . Recoating is also recommended for better performance. However, since we also use our own cutting edge ... 詳細表示