How many Cutting diameter is regrindi...

It can be processed from 3 mm. 詳細表示

How many hole depths can the ADF-2D b...

Basically, since the helix angle is low, the chip discharge is lower than that of conventional drills, so it can be processed in 2D. It is possible to proce... 詳細表示

What is the shank accuracy of ADF and...

The shank accuracy catalog display [SHRINK FIT] means that it is compatible with the shrink fit system. The actual tolerance is h6. 詳細表示

ADF-2D and ADFO-3D back-taper amount ...

In order to cope with intermittent cutting, it is strong at 0.45 ~ 0.50 / 100 mm. 詳細表示

What is the guideline for adjusting c...

The standard guideline for adjusting cutting conditions in through‑hole machining of curved surfaces in the ADF series is as follows: To minimize burrs at... 詳細表示

What is the guideline for correction ...

Reduce the number of speed (min-1) to 60%. The feed per revolution (mm/rev) does not need to be changed as long as it is within the catalog range. 詳細表示

Flat drill ADF doesn't twist that str...

In order to ensure sharpness, it is common to the high helix angle and sharpen the cutting edge. The ADF series does this with a unique cutting edge shape. ... 詳細表示

Difference Between Flat Drill and End...

The difference between a flat drill (ADF series) and an end mill for counterboring (ZDS series) is as follows: ADF can be machined to twice the depth of the... 詳細表示

Can the long shank specification of t...

As per the model number of ADFLS-2D, the maximum machining depth is up to 2D. The long shank specification is designed to reach distant processing areas. ... 詳細表示

What is the guideline for adjusting c...

When machining surfaces with an inclination angle of 30° or less, use a feed rate of 40-60% of the values in the cutting conditions reference table as a guid... 詳細表示