Can the long shank specification of t...

Can the long shank specification of the ADF series of carbide flat drills also be used for deep hole drilling? As per the model number of ADFLS-2D, the ma... 詳細表示

Difference Between Flat Drill and cou...

Difference Between Flat Drill and counterboring End Mill The difference between a flat drill (ADF series) and an end mill for counterboring (ZDS series) is... 詳細表示

If the rigidity of the tool is good, ...

The high stiffness of the ADF is due to the weak torsion groove of 20 degrees. The unique groove shape and smoothing process achieve both chip discharge and... 詳細表示

Flat drill ADF doesn't twist that str...

Flat drill ADF doesn't twist that strongly, so why does the cutting edge have a good sharpness? In order to ensure sharpness, it is common to strength... 詳細表示

What is the guideline for correction ...

Reduce the number of revolutions to 60%. The feed rate per revolution does not need to be changed as long as it is within the catalog range. 詳細表示

What is the guideline for correction ...

What is the guideline for correction of cutting conditions in through hole machining of curved surfaces of the ADF series? The standard for correcting cutti... 詳細表示

What is the blade diameter tolerance ...

The blade diameter tolerance of ADF-2D is as follows:Outer diameter 2 or more is H8,Outer diameter less than 2 is 0~-0.009. 詳細表示

ADF-2D and ADFO-3D back-taper amount ...

Backtaper amount of ADF-2D and ADFO-3D? In order to cope with intermittent cutting, it is strong at 0.45 ~ 0.50 / 100 mm. 詳細表示

What is the shank accuracy of ADF and...

What is the shank accuracy of ADF and ADFO? The shank accuracy catalog display [SHRINK FIT] means that it is compatible with the shrink fit system. The act... 詳細表示

How many hole depths can the ADF-2D b...

Basically, since the helix angle is weak, the chip discharge is lower than that of conventional drills, so it can be processed in 2D. It is possible to proc... 詳細表示