What is the tolerance for drill diame...

The tolerance for drill diameter of ADF-2D is as follows: For outside diameters of 2 mm or larger: h8 For outside diameters smaller than 2 mm: 0 to −0.009 ... 詳細表示

ADO-SUS drill chipping of cutting edge

After centering the 90-degree tip angle, which also serves as a chamfer, it is machined with an ADO-SUS drill, but the cutting edge frequently chipping . How... 詳細表示

How should flat drills and a drill wi...

Applications Where flat drills are advantageous Drilling in the inclined surface (at the entrance and pull out) Drilling holes on surfaces with uneven su... 詳細表示

How many Cutting diameter to double ...

φ3 mm or more is a double margin. 詳細表示

Does the ADFO-3D have honing (chamfer...

It comes with honing (chamfer) 詳細表示

Flat drill ADF doesn't twist that str...

In order to ensure sharpness, it is common to the high helix angle and sharpen the cutting edge. The ADF series does this with a unique cutting edge shape. ... 詳細表示

ADFLS-2D does not provide hole positi...

If the hole position accuracy is unstable with a long-shank type like ADFLS-2D, pre-centering with a diameter larger than the tool is effective. Because t... 詳細表示

What should I do when machining titan...

When machining titanium alloys, if bellows-shaped chips are produced, this phenomenon is likely caused by cutting conditions being too fast. Reduce the cutt... 詳細表示

The oil hole shape of the ADO-SUS dri...

It is a new type of oil hole called MEGA COOLER. Compared to the general specifications, it has a discharge rate of more than 30%, and is highly effective in... 詳細表示

ADO-SUS series and EX-SUS series. A w...

The main difference is the tool material. The ADO-SUS drill series is made of carbide and has internal coolant supply specifications. internal coolant su... 詳細表示