Is it possible to process half-hole?　...

Half-Hole is possible. However, it is necessary to adjust the cutting conditions. Reference: Processing half-hole 詳細表示

Centering of a long shank flat drill ...

For long-shank flat drills with long overhang lengths, such as ADFLS-2D, we recommended centering to reduce runout when the drill engages the hole. The guid... 詳細表示

When to use ADO drills and ADO-SUS dr...

Mainly, ADO-SUS drills are recommended for machining stainless steel, titanium alloys. For carbon steels, alloy steels, and tempered steels up to 40 HRC, us... 詳細表示

Difference Between Flat Drill and End...

The difference between a flat drill (ADF series) and an end mill for counterboring (ZDS series) is as follows: ADF can be machined to twice the depth of the... 詳細表示

Difference Between ADO-SUS Drill and ...

Difference Between ADO-SUS Drill and ADO Drill The main difference between the two drills is the corresponding workpiece material. The ADO-SUS series is sp... 詳細表示

Is step feeding with an ADO-SUS drill...

It is better not to step because it will be adversely affected by work hardening. When using an non-water-soluble coolant agent, Dwell processing (G04) is r... 詳細表示

What are the features of the ADO-SUS ...

With a larger oil hole shape, the flow velocity of the cutting oil is about 2 times higher and the flow rate is increased by about 1.3 times. This allows fo... 詳細表示

What is the guideline for adjusting c...

When machining surfaces with an inclination angle of 30° or less, use a feed rate of 40-60% of the values in the cutting conditions reference table as a guid... 詳細表示

Can the long shank specification of t...

As per the model number of ADFLS-2D, the maximum machining depth is up to 2D. The long shank specification is designed to reach distant processing areas. ... 詳細表示

I want to make the tip flat with a ho...

I want to make the tip flat with a hole depth of 5D. "ADF and ADFO" After machining a 5D hole with a normal drill with a tip angle, only the tip angle is ma... 詳細表示