Is there a short chamfer type with 1P...

There is no short chamfer type with 1P chamfer length for S-XPF. However, the A-XPF series, which is also a roll tap series, does have a lineup with 1P cham... 詳細表示

Can A-SFT AND A-POT be used in floati...

Can A-SFT AND A-POT be used in floating tupperware? A-SFT AND A-POT are also available in floating tupperware. Please use it at a cutting speed of 15 m/m... 詳細表示

Is it possible to process castings (F...

For threading castings, straight fluted tap is recommended. When castings（FC） to process with A-SFT, it may not be discharged properly because it will be fi... 詳細表示

What is S-XPF?

S-XPF is a forming tap that reduces processing torque and heat generation, and enables rolling of high-hardness materials up to 35 HRC. With a rich lineup f... 詳細表示

What materials are compatible with A ...

SS400, S45C, and SUS are recommended, but only FC is not recommended. Can be used on workpiece materials with a hardness of 30HRC or less that form continuo... 詳細表示

Recommended machining depth for A Tap

Recommended machining depth for A Tap A Tap is recommended to have a machining depth of up to 2.5 times the thread diameter (2D: Dc×2.5). Reference: A Ta... 詳細表示

How deep can S-XPF be drilled?

As with other forming tap , first consider a depth of about 3 times the diameter of the tool. However, it may vary depending on the workpiece material. 詳細表示

Pilot hole diameter of oversize for...

For roll taps, increase the prehole as the tap size increases. Since the RH number is +0.013mm for every 1 increase, In the case of STD+3, STD+0.039mm is a... 詳細表示

High speed machining with A Tap

Yes, if the machine is equipped with a synchronous feed mechanism, cutting speed of 15 m/min or more are possible. Reference: A Tap Series (WEB Worksh... 詳細表示