Difference from A Tap and V-SFT
A-Tap and V-SFT have the same V-coating, but the two taps differ in their base materials and flute specifications. The corresponding workpiece materials are... 詳細表示
Dry processing at A Tap It is okay to use non-water-soluble coolant and water-soluble emulsion type, but we do not recommend water-soluble coolant with poor... 詳細表示
What is the difference between S-XPF ...
Compared to conventional NRT, the S-XPF is a forming tap that can be processed with lower torque and lower heat generation. It is suitable for high-hardness... 詳細表示
High efficiency and multi-functionali...
Thanks to the state-of-the-art coating dedicated to Tap and a special thread geometry that suppresses sudden chipping , the A-XPF enables long- tool life and... 詳細表示
Can A‑Tap machine high‑hardness mater...
A-Tap has a sharp cutting edge, so it is not suitable for high-hardness materials exceeding 30 HRC. For machining high-hardness materials, use Tap suitable f... 詳細表示
The A-Tap series is available in a wide range of oversizes. Please check the catalog. Reference: Oversized A-Tap Series 詳細表示
The protrusion center of the A-SFT has been removed in all sizes. In addition, the A Tap range also includes a short chamfer, which allows for the machining ... 詳細表示
Can asynchronous machines be used wit...
It is also possible with asynchronous machines. For high-efficiency machining with cutting speeds exceeding 15 m/min, a machine with a synchronous feed me... 詳細表示
Should the cutting conditions of the ...
For workpiece materials other than stainless steel, it can be used at nearly twice the speed of conventional products. Reference: S-XPF Introduction 詳細表示
What are the advantages of OIL-S-XPF ...
The OIL-S-XPF with oil hole is capable of mist (MQL) processing. It can also handle high-speed machining with cutting speeds exceeding 30 m/min. Not only ef... 詳細表示
Results:39 ,Showing: 21 - 30