Is it possible to process castings (F...

For threading castings, straight fluted tap is recommended. When castings（FC） to process with A-SFT, it may not be discharged properly because it will be fi... 詳細表示

What materials are compatible with A ...

SS400, S45C, and SUS are recommended, but only FC is not recommended. Can be used on workpiece materials with a hardness of 30HRC or less that form continuo... 詳細表示

Should the cutting conditions of the ...

For workpiece materials other than stainless steel, it can be used at nearly twice the speed of conventional products. Reference: S-XPF Introduction 詳細表示

Pilot hole diameter of oversize for...

For roll taps, increase the prehole as the tap size increases. Since the RH number is +0.013mm for every 1 increase, In the case of STD+3, STD+0.039mm is a... 詳細表示

Can A‑Tap machine high‑hardness mater...

A-Tap has a sharp cutting edge, so it is not suitable for high-hardness materials exceeding 30 HRC. For machining high-hardness materials, use Tap suitable f... 詳細表示

Is it possible to process Inconel and...

Is it possible to process Inconel and Hastelloy with A-TPT for tapered threads for pipes? Basically, we do not recommend it. For tapered pipe threading of ... 詳細表示

A-Tap series oversized

The A-Tap series is available in a wide range of oversizes. Please check the catalog. Reference: Oversized A-Tap Series 詳細表示

Can A Tap be processedraw steel or t...

A-Tap can be used for machining workpieces up to 30 HRC. For materials exceeding 30 HRC, a tap specifically designed for higher hardness is required. Ref... 詳細表示

Use of S-XPF in stainless steel

For use on stainless steel, it is recommended to use an insoluble cutting fluid or a water-soluble cutting fluid with highly lubricity. References: Cutting ... 詳細表示

Is there a short chamfer type with 1P...

There is no short chamfer type with 1P chamfer length for S-XPF. However, the A-XPF series, which is also a roll tap series, does have a lineup with 1P cham... 詳細表示