Should the cutting conditions of the ...
For workpiece materials other than stainless steel, it can be used at nearly twice the speed of conventional products. Reference: S-XPF Introduction 詳細表示
Can asynchronous machines be used wit...
It is also possible with asynchronous machines. For high-efficiency machining with cutting speeds exceeding 15 m/min, a machine with a synchronous feed me... 詳細表示
The protrusion center of the A-SFT has been removed in all sizes. In addition, the A Tap range also includes a short chamfer, which allows for the machining ... 詳細表示
The A-Tap series is available in a wide range of oversizes. Please check the catalog. Reference: Oversized A-Tap Series 詳細表示
Can A‑Tap machine high‑hardness mater...
A-Tap has a sharp cutting edge, so it is not suitable for high-hardness materials exceeding 30 HRC. For machining high-hardness materials, use Tap suitable f... 詳細表示
High efficiency and multi-functionali...
Thanks to the state-of-the-art coating dedicated to Tap and a special thread geometry that suppresses sudden chipping , the A-XPF enables long- tool life and... 詳細表示
What is the difference between S-XPF ...
Compared to conventional NRT, the S-XPF is a forming tap that can be processed with lower torque and lower heat generation. It is suitable for high-hardness... 詳細表示
Dry processing at A Tap It is okay to use non-water-soluble coolant and water-soluble emulsion type, but we do not recommend water-soluble coolant with poor... 詳細表示
Difference from A Tap and V-SFT
A-Tap and V-SFT have the same V-coating, but the two taps differ in their base materials and flute specifications. The corresponding workpiece materials are... 詳細表示
What is A Tap ? What are its features...
A Tap is a Tap that realizes stable thread processing with its strength of "outstanding chip ejection performance" in a wide range of workpiece materials and... 詳細表示
Results:39 ,Showing: 11 - 20