High speed machining with A Tap

Yes, if the machine is equipped with a synchronous feed mechanism, cutting speed of 15 m/min or more are possible. Reference: A Tap Series (WEB Worksh... 詳細表示

Pilot hole diameter of oversize for...

For roll taps, increase the prehole as the tap size increases. Since the RH number is +0.013mm for every 1 increase, In the case of STD+3, STD+0.039mm is a... 詳細表示

How deep can S-XPF be drilled?

As with other forming tap , first consider a depth of about 3 times the diameter of the tool. However, it may vary depending on the workpiece material. 詳細表示

Recommended machining depth for A Tap

Recommended machining depth for A Tap A Tap is recommended to have a machining depth of up to 2.5 times the thread diameter (2D: Dc×2.5). Reference: A Ta... 詳細表示

What materials are compatible with A ...

SS400, S45C, and SUS are recommended, but only FC is not recommended. Can be used on workpiece materials with a hardness of 30HRC or less that form continuo... 詳細表示

What is S-XPF?

S-XPF is a forming tap that reduces processing torque and heat generation, and enables rolling of high-hardness materials up to 35 HRC. With a rich lineup f... 詳細表示

Is it possible to process castings (F...

For threading castings, straight fluted tap is recommended. When castings（FC） to process with A-SFT, it may not be discharged properly because it will be fi... 詳細表示

Can A-SFT AND A-POT be used in floati...

Can A-SFT AND A-POT be used in floating tupperware? A-SFT AND A-POT are also available in floating tupperware. Please use it at a cutting speed of 15 m/m... 詳細表示

Is there a short chamfer type with 1P...

There is no short chamfer type with 1P chamfer length for S-XPF. However, the A-XPF series, which is also a roll tap series, does have a lineup with 1P cham... 詳細表示

What are the advantages of OIL-S-XPF ...

The OIL-S-XPF with oil hole is capable of mist (MQL) processing. It can also handle high-speed machining with cutting speeds exceeding 30 m/min. Not only ef... 詳細表示