What is the A-Tap series? What kind o...

A-Tap is a next-generation tap with a strong base metal and a V-coating with excellent heat resistance and wear resistance . It is compatible with a wide ran... 詳細表示

Carbide Flat Drill What is ADF?

Carbide Flat Drill What is ADF? Drills that can be used on inclined and curved surfaces with high efficiency Carbide flat drills ADF / ADFO series. Th... 詳細表示

Recommended machining depth for A Tap

Recommended machining depth for A Tap A Tap is recommended to have a machining depth of up to 2.5 times the thread diameter (2D: Dc×2.5). Reference: A Ta... 詳細表示

What is an end mill that can process ...

If there is an indication for a right-angle corner in the drawing, the end mill side must also be at a right angle. However, in the case of a typical carbide... 詳細表示

Is it possible to process Inconel and...

Is it possible to process Inconel and Hastelloy with A-TPT for tapered threads for pipes? Basically, we do not recommend it. For tapered pipe threading of ... 詳細表示

Use of S-XPF in stainless steel

For use on stainless steel, it is recommended to use an insoluble cutting fluid or a water-soluble cutting fluid with highly lubricity. References: Cutting ... 詳細表示

High efficiency and multi-functionali...

Thanks to the state-of-the-art coating dedicated to Tap and a special thread geometry that suppresses sudden chipping , the A-XPF enables long- tool life and... 詳細表示

When using AE-VTSS for plunge cutting...

Since this end mill has a relief angle, plunge cutting alone will not produce a flat bottom surface. However, if you follow up with lateral cutting or simil... 詳細表示

What is AE-VTSS,carbide anti-vibratio...

AE-VTSS is a carbide anti-vibration end mill designed with optimal specifications for machining on automatic lathes, featuring the following characteristics:... 詳細表示

Can AE-CPR4-H be reground? 4-flute lo...

Regrinding of AE-CPR4-H is not supported. 詳細表示