Is there a short chamfer type with 1P...

There is no short chamfer type with 1P chamfer length for S-XPF. However, the A-XPF series, which is also a roll tap series, does have a lineup with 1P cham... 詳細表示

What are the benefits of S-XPF torque...

XPF, which has low torque and low heat generation, can be used for rolling large-diameter, high-hardness materials. It is also effective for high-speed, lon... 詳細表示

What is the difference between S-XPF ...

Compared to conventional NRT, the S-XPF is a forming tap that can be processed with lower torque and lower heat generation. It is suitable for high-hardness... 詳細表示

How hard can S-XPF be processed?

As a guideline, it is possible to process 35 HRC or less. 詳細表示

There are P and B on the S-XPF inscri...

The P and B shown on the Tap shank represent the chamfer length of the forming tap . The P (plug) is 4 pitches long for through hole , and the B (bottom) is... 詳細表示

Pilot hole diameter of oversize for...

For roll taps, increase the prehole as the tap size increases. Since the RH number is +0.013mm for every 1 increase, In the case of STD+3, STD+0.039mm is a... 詳細表示

Should the cutting conditions of the ...

For workpiece materials other than stainless steel, it can be used at nearly twice the speed of conventional products. Reference: S-XPF Introduction 詳細表示

How deep can S-XPF be drilled?

As with other forming tap , first consider a depth of about 3 times the diameter of the tool. However, it may vary depending on the workpiece material. 詳細表示

What is the model number of the A-SFT...

What is the model number of the A-SFT end mill shank specification? There is no special model number, and it remains A-SFT. You can distinguish the... 詳細表示

A Tap , Use in drilling machine

The A-Tap can also be used on manual drilling machines. However, tapping requires one pitch per revolution (for single-start threads). When processing with ... 詳細表示