How many hole depths can the ADF-2D b...

Basically, since the helix angle is low, the chip discharge is lower than that of conventional drills, so it can be processed in 2D. It is possible to proce... 詳細表示

ADF-2D and ADFO-3D back-taper amount ...

In order to cope with intermittent cutting, it is strong at 0.45 ~ 0.50 / 100 mm. 詳細表示

What is the guideline for adjusting c...

The standard guideline for adjusting cutting conditions in through‑hole machining of curved surfaces in the ADF series is as follows: To minimize burrs at... 詳細表示

I bought an ADO-SUS drill 6mm, but th...

ADO-SUS drills have round oil holes up to φ6. It uses a special shape MEGA COOLER that can secure a larger amount of coolant discharge than the round type... 詳細表示

Is there an insert screw in the A-SFT?

Is there an insert screw in the A-SFT?? There is a product called A-SFT-HL. This is a Tap that processes a screw with a larger outer diameter (same pitch) t... 詳細表示

Difference from A Tap and VP-SFT

A-SFT is recommended up to 30HRC. VP-SFT is recommended for harder materials (30~42HRC). References: A Tap Series 詳細表示

Can A Tap be processedraw steel or t...

A-Tap can be used for machining workpieces up to 30 HRC. For materials exceeding 30 HRC, a tap specifically designed for higher hardness is required. Ref... 詳細表示

Dry processing in A Tap

Dry processing at A Tap It is okay to use non-water-soluble coolant and water-soluble emulsion type, but we do not recommend water-soluble coolant with poor... 詳細表示

Should the cutting conditions of the ...

For workpiece materials other than stainless steel, it can be used at nearly twice the speed of conventional products. Reference: S-XPF Introduction 詳細表示

What are the advantages of OIL-S-XPF ...

The OIL-S-XPF with oil hole is capable of mist (MQL) processing. It can also handle high-speed machining with cutting speeds exceeding 30 m/min. Not only ef... 詳細表示