When using AE-VTSS for plunge cutting...

Since this end mill has a relief angle, plunge cutting alone will not produce a flat bottom surface. However, if you follow up with lateral cutting or simil... 詳細表示

How hard can S-XPF be processed?

As a guideline, it is possible to process 35 HRC or less. 詳細表示

What are the features of the ADO-SUS ...

With a larger oil hole shape, the flow velocity of the cutting oil is about 2 times higher and the flow rate is increased by about 1.3 times. This allows fo... 詳細表示

ADFLS-2D does not provide hole positi...

If the hole position accuracy is unstable with a long-shank type like ADFLS-2D, pre-centering with a diameter larger than the tool is effective. Because t... 詳細表示

How many Cutting diameter to double ...

φ3 mm or more is a double margin. 詳細表示

I bought an ADO-SUS drill 6mm, but th...

ADO-SUS drills have round oil holes up to φ6. It uses a special shape MEGA COOLER that can secure a larger amount of coolant discharge than the round type... 詳細表示

Should step machining be performed wh...

When machining stainless steel in the ADO-SUS series, non-step machining is generally recommended. This is because step machining increases contact with the... 詳細表示

Is it okay to use the same program wh...

Is it okay to use the same program when using a new AT-1 from the conventional product that has been used so far? Since the shape of the tool has changed,... 詳細表示

What are the features of the AT-1? "T...

The AT-1 uses a right-hand cut and a left-hand helix to prevent tool deflection , evolution from conventional two-pass machining to one-pass machining. The ... 詳細表示

How many Cutting diameter is regrindi...

It can be processed from 3 mm. 詳細表示