Can AT-2 be reground？

AT-2 cannot be reground. 詳細表示

Measures against internal burrs in th...

Measures against internal burrs in the side hole processing of pipes "ADF and ADFO" The ADF-2D and ADFO-3D series are effective for internal burrs in the si... 詳細表示

How should flat drills and a drill wi...

Applications Where flat drills are advantageous Drilling in the inclined surface (at the entrance and pull out) Drilling holes on surfaces with uneven su... 詳細表示

When to use ADO drills and ADO-SUS dr...

Mainly, ADO-SUS drills are recommended for machining stainless steel, titanium alloys. For carbon steels, alloy steels, and tempered steels up to 40 HRC, us... 詳細表示

Is it possible to process Inconel and...

Is it possible to process Inconel and Hastelloy with A-TPT for tapered threads for pipes? Basically, we do not recommend it. For tapered pipe threading of ... 詳細表示

A-Tap series oversized

The A-Tap series is available in a wide range of oversizes. Please check the catalog. Reference: Oversized A-Tap Series 詳細表示

Can A Tap be processedraw steel or t...

A-Tap can be used for machining workpieces up to 30 HRC. For materials exceeding 30 HRC, a tap specifically designed for higher hardness is required. Ref... 詳細表示

Use of S-XPF in stainless steel

For use on stainless steel, it is recommended to use an insoluble cutting fluid or a water-soluble cutting fluid with highly lubricity. References: Cutting ... 詳細表示

Is there a short chamfer type with 1P...

There is no short chamfer type with 1P chamfer length for S-XPF. However, the A-XPF series, which is also a roll tap series, does have a lineup with 1P cham... 詳細表示

Can the high-efficiency thread mill A...

Can the high-efficiency thread mill AT-2 R-SPEC with non-ferrous end cutting edge be used without cutting oil? Basically, water-soluble cutting oil is recom... 詳細表示