Does AE-VTSS have a flat-bottom finis...
This end mill is not designed with a flat-bottom finishing edge. ・ What is AE-VTSS? 詳細表示
How hard can S-XPF be processed?
As a guideline, it is possible to process 35 HRC or less. 詳細表示
Can asynchronous machines be used wit...
It is also possible with asynchronous machines. For high-efficiency machining with cutting speeds exceeding 15 m/min, a machine with a synchronous feed me... 詳細表示
The A-Tap series is available in a wide range of oversizes. Please check the catalog. Reference: Oversized A-Tap Series 詳細表示
ADO-SUS drill chipping of cutting edge
After centering the 90-degree tip angle, which also serves as a chamfer, it is machined with an ADO-SUS drill, but the cutting edge frequently chipping . How... 詳細表示
What is the tolerance for drill diame...
The tolerance for drill diameter of ADF-2D is as follows: For outside diameters of 2 mm or larger: h8 For outside diameters smaller than 2 mm: 0 to −0.009 ... 詳細表示
Measures against internal burrs in th...
Measures against internal burrs in the side hole processing of pipes "ADF and ADFO" The ADF-2D and ADFO-3D series are effective for internal burrs in the si... 詳細表示
A end mill series that can be used fo...
In addition to a wide range of materials such as S50C, SS400, SUS, and aluminum, the AE-VM series is recommended for end mills that can handle various proces... 詳細表示
What is Thread Mill AT-2 with end cut...
It is a thread mill with end cutting edge for high-hardness steel. Helical drilling and threading can be performed simultaneously. In the threading on hi... 詳細表示
Is there a short chamfer type with 1P...
There is no short chamfer type with 1P chamfer length for S-XPF. However, the A-XPF series, which is also a roll tap series, does have a lineup with 1P cham... 詳細表示
Results:127 ,Showing: 71 - 80