How should flat drills and a drill wi...

Applications Where flat drills are advantageous Drilling in the inclined surface (at the entrance and pull out) Drilling holes on surfaces with uneven su... 詳細表示

Centering of a long shank flat drill ...

For long-shank flat drills with long overhang lengths, such as ADFLS-2D, we recommended centering to reduce runout when the drill engages the hole. The guid... 詳細表示

Is it possible to process half-hole?　...

Half-Hole is possible. However, it is necessary to adjust the cutting conditions. Reference: Processing half-hole 詳細表示

What is the guideline for correction ...

Reduce the number of speed (min-1) to 60%. The feed per revolution (mm/rev) does not need to be changed as long as it is within the catalog range. 詳細表示

Difference from A Tap and V-SFT

A-Tap and V-SFT have the same V-coating, but the two taps differ in their base materials and flute specifications. The corresponding workpiece materials are... 詳細表示

Dry processing in A Tap

Dry processing at A Tap It is okay to use non-water-soluble coolant and water-soluble emulsion type, but we do not recommend water-soluble coolant with poor... 詳細表示

What is the difference between S-XPF ...

Compared to conventional NRT, the S-XPF is a forming tap that can be processed with lower torque and lower heat generation. It is suitable for high-hardness... 詳細表示

High efficiency and multi-functionali...

Thanks to the state-of-the-art coating dedicated to Tap and a special thread geometry that suppresses sudden chipping , the A-XPF enables long- tool life and... 詳細表示

Does AE-VTSS have a flat-bottom finis...

This end mill is not designed with a flat-bottom finishing edge. ・ What is AE-VTSS? 詳細表示

Can AT-2 R-SPEC be reground? High ef...

AT-2 R-SPEC cannot be reground . 詳細表示