What is the guideline for adjusting c...

The standard guideline for adjusting cutting conditions in through‑hole machining of curved surfaces in the ADF series is as follows: To minimize burrs at... 詳細表示

What is the shank accuracy of ADF and...

The shank accuracy catalog display [SHRINK FIT] means that it is compatible with the shrink fit system. The actual tolerance is h6. 詳細表示

Optimal specifications according to t...

Optimal specifications according to the processing depth! Drill ADO Series with Carbide Oil Hole Aren't the specifications of the drills the same, just the ... 詳細表示

If a long flute length end mill is cu...

The long flute type AE-VML of the AE-VM series is available with a chip breaker . The cutting edge has a groove called a nick that separates the chips. A... 詳細表示

Unlike other thread mills, the AT-2 h...

The AT-2, a thread mill with end cutting edge for high-hardness steel, is a left-hand blade specification (= used with left-hand rotation of the tool). ... 詳細表示

Can AE-MS-H regrinding ?

Can AE-MS-H regrinding ? regrinding is possible. In order to ensure performance, recoating is also recommended. If you are considering recoating and... 詳細表示

What are the types of cutting fluid w...

What are the types of cutting fluid when using AE-LNBD-N and what should they be used properly? Basically, we recommend "water-soluble coolant". If you... 詳細表示

Can AT-2 R-SPEC be reground? High ef...

AT-2 R-SPEC cannot be reground . 詳細表示

Does AE-VTSS have a flat-bottom finis...

This end mill is not designed with a flat-bottom finishing edge. ・ What is AE-VTSS? 詳細表示

High efficiency and multi-functionali...

Thanks to the state-of-the-art coating dedicated to Tap and a special thread geometry that suppresses sudden chipping , the A-XPF enables long- tool life and... 詳細表示