Should step machining be performed wh...

When machining stainless steel in the ADO-SUS series, non-step machining is generally recommended. This is because step machining increases contact with the... 詳細表示

I bought an ADO-SUS drill 6mm, but th...

ADO-SUS drills have round oil holes up to φ6. It uses a special shape MEGA COOLER that can secure a larger amount of coolant discharge than the round type... 詳細表示

How many Cutting diameter to double ...

φ3 mm or more is a double margin. 詳細表示

ADFLS-2D does not provide hole positi...

If the hole position accuracy is unstable with a long-shank type like ADFLS-2D, pre-centering with a diameter larger than the tool is effective. Because t... 詳細表示

What are the features of the ADO-SUS ...

With a larger oil hole shape, the flow velocity of the cutting oil is about 2 times higher and the flow rate is increased by about 1.3 times. This allows fo... 詳細表示

How hard can S-XPF be processed?

As a guideline, it is possible to process 35 HRC or less. 詳細表示

When using AE-VTSS for plunge cutting...

Since this end mill has a relief angle, plunge cutting alone will not produce a flat bottom surface. However, if you follow up with lateral cutting or simil... 詳細表示

Does the ADFO-3D have honing (chamfer...

It comes with honing (chamfer) 詳細表示

ADF-2D and ADFO-3D back-taper amount ...

In order to cope with intermittent cutting, it is strong at 0.45 ~ 0.50 / 100 mm. 詳細表示

< Why does AE-VML > is it less likely...

This is because it has a web tapered specification that thickens the thickness of core from the cutting edge to the shank. It is even more rigid than convent... 詳細表示