The protrusion center of the A-SFT has been removed in all sizes. In addition, the A Tap range also includes a short chamfer, which allows for the machining ... 詳細表示
Is step feeding with an ADO-SUS drill...
It is better not to step because it will be adversely affected by work hardening. When using an non-water-soluble coolant agent, Dwell processing (G04) is r... 詳細表示
What are the coatings of the ADF series?
It is called EgiAs coating. It is a composite multilayer coating that suppresses wear with a wear-resistant layer and prevents crack propagation with nano-pe... 詳細表示
Can the long shank specification of t...
As per the model number of ADFLS-2D, the maximum machining depth is up to 2D. The long shank specification is designed to reach distant processing areas. ... 詳細表示
A end mill series that can be used fo...
In addition to a wide range of materials such as S50C, SS400, SUS, and aluminum, the AE-VM series is recommended for end mills that can handle various proces... 詳細表示
What is the good DUROREY coating appl...
What is the good DUROREY coating applied to end mills for high-hardness steel? The DUROREY coating consists of an ultra-heat-resistant layer containing SiC ... 詳細表示
Can AE-MS-H regrinding ? regrinding is possible. In order to ensure performance, recoating is also recommended. If you are considering recoating and... 詳細表示
Can the high-efficiency thread mill A...
Can the high-efficiency thread mill AT-2 R-SPEC with non-ferrous end cutting edge be used without cutting oil? Basically, water-soluble cutting oil is recom... 詳細表示
Is there a short chamfer type with 1P...
There is no short chamfer type with 1P chamfer length for S-XPF. However, the A-XPF series, which is also a roll tap series, does have a lineup with 1P cham... 詳細表示
Use of S-XPF in stainless steel
For use on stainless steel, it is recommended to use an insoluble cutting fluid or a water-soluble cutting fluid with highly lubricity. References: Cutting ... 詳細表示
Results:127 ,Showing: 41 - 50