Can The ADO-SUS drill series be regr...

The ADO-SUS drill series can be reground . Recoating is also recommended for better performance. However, since we also use our own cutting edge specificati... 詳細表示

Should step machining be performed wh...

When machining stainless steel in the ADO-SUS series, non-step machining is generally recommended. This is because step machining increases contact with the... 詳細表示

Can the long shank specification of t...

As per the model number of ADFLS-2D, the maximum machining depth is up to 2D. The long shank specification is designed to reach distant processing areas. ... 詳細表示

What is the guideline for correction ...

Reduce the number of speed (min-1) to 60%. The feed per revolution (mm/rev) does not need to be changed as long as it is within the catalog range. 詳細表示

What is the guideline for adjusting c...

The standard guideline for adjusting cutting conditions in through‑hole machining of curved surfaces in the ADF series is as follows: To minimize burrs at... 詳細表示

< Why does AE-VML > is it less likely...

This is because it has a web tapered specification that thickens the thickness of core from the cutting edge to the shank. It is even more rigid than convent... 詳細表示

How many hole depths can the ADF-2D b...

Basically, since the helix angle is low, the chip discharge is lower than that of conventional drills, so it can be processed in 2D. It is possible to proce... 詳細表示

How many Cutting diameter is regrindi...

It can be processed from 3 mm. 詳細表示

Does the ADFO-3D have honing (chamfer...

It comes with honing (chamfer) 詳細表示

Centering of a long shank flat drill ...

For long-shank flat drills with long overhang lengths, such as ADFLS-2D, we recommended centering to reduce runout when the drill engages the hole. The guid... 詳細表示