ADF-2D and ADFO-3D back-taper amount ...

In order to cope with intermittent cutting, it is strong at 0.45 ~ 0.50 / 100 mm. 詳細表示

How many hole depths can the ADF-2D b...

Basically, since the helix angle is low, the chip discharge is lower than that of conventional drills, so it can be processed in 2D. It is possible to proce... 詳細表示

How deep can S-XPF be drilled?

As with other forming tap , first consider a depth of about 3 times the diameter of the tool. However, it may vary depending on the workpiece material. 詳細表示

Difference from A Tap and V-SFT

A-Tap and V-SFT have the same V-coating, but the two taps differ in their base materials and flute specifications. The corresponding workpiece materials are... 詳細表示

Difference from A Tap and VP-SFT

A-SFT is recommended up to 30HRC. VP-SFT is recommended for harder materials (30~42HRC). References: A Tap Series 詳細表示

What is the A-Tap series? What kind o...

A-Tap is a next-generation tap with a strong base metal and a V-coating with excellent heat resistance and wear resistance . It is compatible with a wide ran... 詳細表示

Is there a general-purpose drill that...

A general-purpose drill that is carbide and can be used in external coolant supply instead of internal coolant supply is AD-2D and AD-4D are available. U... 詳細表示

I bought an ADO-SUS drill 6mm, but th...

ADO-SUS drills have round oil holes up to φ6. It uses a special shape MEGA COOLER that can secure a larger amount of coolant discharge than the round type... 詳細表示

What is the guideline for adjusting c...

The standard guideline for adjusting cutting conditions in through‑hole machining of curved surfaces in the ADF series is as follows: To minimize burrs at... 詳細表示

Centering of a long shank flat drill ...

For long-shank flat drills with long overhang lengths, such as ADFLS-2D, we recommended centering to reduce runout when the drill engages the hole. The guid... 詳細表示