There are P and B on the S-XPF inscri...

The P and B shown on the Tap shank represent the chamfer length of the forming tap . The P (plug) is 4 pitches long for through hole , and the B (bottom) is... 詳細表示

How hard can S-XPF be processed?

As a guideline, it is possible to process 35 HRC or less. 詳細表示

What are the advantages of OIL-S-XPF ...

The OIL-S-XPF with oil hole is capable of mist (MQL) processing. It can also handle high-speed machining with cutting speeds exceeding 30 m/min. Not only ef... 詳細表示

What is the difference between S-XPF ...

Compared to conventional NRT, the S-XPF is a forming tap that can be processed with lower torque and lower heat generation. It is suitable for high-hardness... 詳細表示

Is there a short chamfer type with 1P...

There is no short chamfer type with 1P chamfer length for S-XPF. However, the A-XPF series, which is also a roll tap series, does have a lineup with 1P cham... 詳細表示

Does AE-VTSS have a flat-bottom finis...

This end mill is not designed with a flat-bottom finishing edge. ・ What is AE-VTSS? 詳細表示

I bought an ADO-SUS drill 6mm, but th...

ADO-SUS drills have round oil holes up to φ6. It uses a special shape MEGA COOLER that can secure a larger amount of coolant discharge than the round type... 詳細表示