Pilot hole diameter of oversize for...

For roll taps, increase the prehole as the tap size increases. Since the RH number is +0.013mm for every 1 increase, In the case of STD+3, STD+0.039mm is a... 詳細表示

Coverage of AE-VMFE for deep side mil...

The AE-VMFE supports up to a depth of 8D (8 times the diameter of the tool). ・ Click here for the AE-VM series catalog 詳細表示

What is AE-LNBD-N?

What is AE-LNBD-N? DLC carbide end mill for copper electrode This is a 2-flute long neck ball type for high-precision finishing. It is effective in suppres... 詳細表示

What is the difference between the A ...

What is the difference between additive manufacturing (AM) end mills and high hardness steel end mills? Additive manufacturing (AM) end mills are charac... 詳細表示

Ball End Mill for High Hardness Steel

OSG has a lineup of ball end mills for high hardness according to the application. OSG has a lineup of ball end mills (A end mill series) for high hardn... 詳細表示

The new normal of 3-flute drills! Wha...

The new normal of 3-flute drills! What is ADO-TRS? I want to improve my drilling process. I hear that a 3-flute drill is more difficult to use than a 2-flu... 詳細表示

How many hole depths can the ADF-2D b...

Basically, since the helix angle is low, the chip discharge is lower than that of conventional drills, so it can be processed in 2D. It is possible to proce... 詳細表示

What is the tolerance for drill diame...

The tolerance for drill diameter of ADF-2D is as follows: For outside diameters of 2 mm or larger: h8 For outside diameters smaller than 2 mm: 0 to −0.009 ... 詳細表示

What is the guideline for adjusting c...

When machining surfaces with an inclination angle of 30° or less, use a feed rate of 40-60% of the values in the cutting conditions reference table as a guid... 詳細表示

Can I use ADO-SUS drills with drillin...

We don't recommend it. Since it is used in a high cutting conditions range, it is necessary to grip the tool with high precision and rigidity, and to hold th... 詳細表示