Is it possible to support deep hole d...

Is it possible to support deep hole drilling with A-SFT? The A-SFT supports effective thread depths up to 2.5D (2.5 times the outer diameter of the thread).... 詳細表示

Is it possible to use non-water-solub...

Is it possible to use non-water-soluble coolant (internal coolant) in ADO-SUS drills? Compared to water-soluble coolant, the cooling effect and oil discharg... 詳細表示

What should I do when machining titan...

When machining titanium alloys, if bellows-shaped chips are produced, this phenomenon is likely caused by cutting conditions being too fast. Reduce the cutt... 詳細表示

What is ADFO, a flat drill with carbi...

What is ADFO, a flat drill with carbide oil holes? Compatible with stainless steel, the flat drill that can process up to 3 times the diameter of the tool i... 詳細表示

Difference from A Tap and VP-SFT

A-SFT is recommended up to 30HRC. VP-SFT is recommended for harder materials (30~42HRC). References: A Tap Series 詳細表示

What is the sharp corner edge for ADF...

It will be the sharp corner edge. It is a specification that allows you to aim for a right-angle shape at the bottom of the hole. * The ADF and ADFO ... 詳細表示

What is an end mill that can process ...

If there is an indication for a right-angle corner in the drawing, the end mill side must also be at a right angle. However, in the case of a typical carbide... 詳細表示

Use of S-XPF in stainless steel

For use on stainless steel, it is recommended to use an insoluble cutting fluid or a water-soluble cutting fluid with highly lubricity. References: Cutting ... 詳細表示

What is a high-performance DLC end mi...

What is a high-performance DLC end mill for non-ferrous metals AE-VTS-N? We will introduce in detail the end mill AE-VTS-N, which can process non-ferrous me... 詳細表示

What is Thread Mill AT-2 with end cut...

It is a thread mill with end cutting edge for high-hardness steel. Helical drilling and threading can be performed simultaneously. In the threading on hi... 詳細表示