Is it possible to process castings (F...

For threading castings, straight fluted tap is recommended. When castings（FC） to process with A-SFT, it may not be discharged properly because it will be fi... 詳細表示

What is S-XPF?

S-XPF is a forming tap that reduces processing torque and heat generation, and enables rolling of high-hardness materials up to 35 HRC. With a rich lineup f... 詳細表示

Is there a standard cutting condition...

Our non-ferrous DLC end mills (AE-TS-N, AE-TL-N, AE-VTS-N, PXAL) are also suitable for resin machining. The types of resin listed in the cutting condition t... 詳細表示

Holder selection when using AE-LNBD-N

Holder selection when using AE-LNBD-N Use a rigid holder with as little runout as possible. The shank of the AE-LNNBD-N adopts a high-precision h4 tole... 詳細表示

Unequal lead,unequal division is,what...

For example, in a 4-flute end mill, the two adjacent peripheral flute have different helix angles ( variable lead ), and the 90° division of the end cutting ... 詳細表示

I want to make the tip flat with a ho...

I want to make the tip flat with a hole depth of 5D. "ADF and ADFO" After machining a 5D hole with a normal drill with a tip angle, only the tip angle is ma... 詳細表示

When to use ADO drills and ADO-SUS dr...

Mainly, ADO-SUS drills are recommended for machining stainless steel, titanium alloys. For carbon steels, alloy steels, and tempered steels up to 40 HRC, us... 詳細表示

What materials are compatible with A ...

SS400, S45C, and SUS are recommended, but only FC is not recommended. Can be used on workpiece materials with a hardness of 30HRC or less that form continuo... 詳細表示

Recommended machining depth for A Tap

Recommended machining depth for A Tap A Tap is recommended to have a machining depth of up to 2.5 times the thread diameter (2D: Dc×2.5). Reference: A Ta... 詳細表示

How deep can S-XPF be drilled?

As with other forming tap , first consider a depth of about 3 times the diameter of the tool. However, it may vary depending on the workpiece material. 詳細表示