Can AT-2 be reground？

AT-2 cannot be reground. 詳細表示

When using AE-VTSS for plunge cutting...

Since this end mill has a relief angle, plunge cutting alone will not produce a flat bottom surface. However, if you follow up with lateral cutting or simil... 詳細表示

What are the benefits of S-XPF torque...

XPF, which has low torque and low heat generation, can be used for rolling large-diameter, high-hardness materials. It is also effective for high-speed, lon... 詳細表示

If the ADF flat drill has high rigidi...

The high rigidity of the ADF is due to its shallow 20‑degree spiral flute. The unique flute geometry and smoothing process provide both excellent chip evacu... 詳細表示

What is an end mill that can process ...

If there is an indication for a right-angle corner in the drawing, the end mill side must also be at a right angle. However, in the case of a typical carbide... 詳細表示

What is AE-MSS-H?

What is AE-MSS-H? Carbide end mill for high-hardness steel multiple flutes Square type stub type (= shorter than short type flute length = 1.5D). ▲ T... 詳細表示

Dry processing in A Tap

Dry processing at A Tap It is okay to use non-water-soluble coolant and water-soluble emulsion type, but we do not recommend water-soluble coolant with poor... 詳細表示

What is the A-Tap series? What kind o...

A-Tap is a next-generation tap with a strong base metal and a V-coating with excellent heat resistance and wear resistance . It is compatible with a wide ran... 詳細表示

Is centering required before drilling...

In the ADO, ADO-SUS series, in the case of a flat surface, Alternatively, centering is not required if the processing depth is less than or equal to 8 times... 詳細表示

What is AE-VTSS,carbide anti-vibratio...

AE-VTSS is a carbide anti-vibration end mill designed with optimal specifications for machining on automatic lathes, featuring the following characteristics:... 詳細表示