A end mill series that can be used fo...

In addition to a wide range of materials such as S50C, SS400, SUS, and aluminum, the AE-VM series is recommended for end mills that can handle various proces... 詳細表示

What is Thread Mill AT-2 with end cut...

It is a thread mill with end cutting edge for high-hardness steel. Helical drilling and threading can be performed simultaneously. In the threading on hi... 詳細表示

Can the high-efficiency thread mill A...

Can the high-efficiency thread mill AT-2 R-SPEC with non-ferrous end cutting edge be used without cutting oil? Basically, water-soluble cutting oil is recom... 詳細表示

I would like to know whether AE-VTFE-...

Regrinding is possible. To ensure performance, recoating is also recommended. If you are considering regriding or recoating, please contact the OSG sales... 詳細表示

Is there an insert screw in the A-SFT?

Is there an insert screw in the A-SFT?? There is a product called A-SFT-HL. This is a Tap that processes a screw with a larger outer diameter (same pitch) t... 詳細表示

Is it possible to use non-water-solub...

Is it possible to use non-water-soluble coolant (internal coolant) in ADO-SUS drills? Compared to water-soluble coolant, the cooling effect and oil discharg... 詳細表示

ADFLS-2D does not provide hole positi...

If the hole position accuracy is unstable with a long-shank type like ADFLS-2D, pre-centering with a diameter larger than the tool is effective. Because t... 詳細表示

What is the tolerance for drill diame...

The tolerance for drill diameter of ADF-2D is as follows: For outside diameters of 2 mm or larger: h8 For outside diameters smaller than 2 mm: 0 to −0.009 ... 詳細表示

Can I grab the AT-1 with the shrink-f...

The shank accuracy of the AT-1 is h6 in the JIS fit tolerance, so the shrink-fitting holder can be used. 詳細表示

Is it okay to use the same program wh...

Is it okay to use the same program when using a new AT-1 from the conventional product that has been used so far? Since the shape of the tool has changed,... 詳細表示