Is it possible to adjust the projecti...
Yes, it can be adjusted by rotating the tool during installation. 詳細表示
What hole and boss diameters can be m...
3mm~125mm 詳細表示
What holder types are supported by th...
The Tool Presetter supports BT30, BT40, BT50, HSK40, and HSK63 holders. Other lathe holders are also supported. Please contact your sales representative for... 詳細表示
Disadvantages of camera type <tool pr...
Dislikes light. Do not allow direct exposure to sunlight, spotlights, etc. 詳細表示
What do I need to get started with Sy...
In order to use Synchro Master, you will need the following: SynchroMaster (Holder + Cap) Collet (sold separately) Spanner (sold separately) + ... 詳細表示
How long can the Power Clamp shrink-f...
Continuous operation is possible without time limitation due to short heating time and no risk of overheating. 詳細表示
Is it possible to modify existing too...
Yes, but only for our own tools. Please contact our sales department for details. 詳細表示
The air pressure of the tool presetter is from 0.5 to 0.6 MPa. 詳細表示
Can I buy probes and antennas later? ...
It is available for purchase. ▽Reference: OSG-HAIMER High-Precision Centering System Centro Streamlining work for round holes and round bosses ● Easy-to... 詳細表示
What is the runout accuracy of HAIMER...
All models offer a runout accuracy of ≤ 3 µm (measured at 3D). 詳細表示
Results:65 ,Showing: 1 - 10