Tool selection for thread mills (PT, ...

OSG's program creation tool for thread mills "ThreadPro" can be used to create everything from tool selection to programming. It greatly reduces the time and... 詳細表示

What kind of tool is a thread mill?

What kind of tool is a thread mill? We will introduce you from the basics to how to use it. Thread mills are an ideal solution to deal with threading problem... 詳細表示

Does the finish of the thread mill be...

Since the thread mill is a cantilever tool, it may collapse or deflection due to the load during machining. Due to the deflection, the finish of the screw ma... 詳細表示

What is the difference between a thre...

In internal threading, thread mills and taps are used interchangeably depending on the machining method and the characteristics of the tools. Key points to ... 詳細表示

I would like you to fax the program o...

We do not contact you by fax for the program. You can create a program with ThreadPro, a program creation tool. 詳細表示

What is the minimum amount of room fo...

It is preferable to secure a margin of at least 1.5P for the threadmill Pilot hole , including the margin, but if it is confirmed that the risk of tool inter... 詳細表示

Is it possible to regrinding a solid ...

Since there are multiple types of solid types, it is difficult to judge whether it is possible or not depending on its specifications, diameter, and degree o... 詳細表示

When machining tapered threads for pi...

For pipe screws of the same type, both external thread and internal threads can be shared as long as they are tapered. Combinations (1) Pipe tapered extern... 詳細表示

Are there any solid type (non- chip i...

All solid types such as AT-1 and WX-PNC are for internal thread machining. chip There is an interchangeable type for external thread machining chip . P... 詳細表示

TM3SC 28C36-144-3U of the single-poin...

BIG DAISHOWA OCA32-28 (Straight Collet with Oil Hole) The hydraulic chuck type holder that corresponds to the shank diameter Φ28 is a "hydro chuck". BBT40... 詳細表示