Can the holder for tapered threads (T...

It's possible. On the other hand, even if the standard type TMC holder is equipped with an insert for tapered threads for pipes, it can be used depending on... 詳細表示

Is there an interchangeable thread mi...

Indexable type ( chip interchangeable) thread mills do not have a lineup that can process PT1/8 and PT1/4. Please use a solid type thread mill for AT-1 tape... 詳細表示

The basic packaging unit of the inser...

Inserts for single-point holders Insert size: 2U / 3U 1 case 5 pieces Inserts for multi-point holders Insert size: 2 / 3 1 case 5 pieces Insert size:... 詳細表示

What is the difference between a thre...

In internal threading, thread mills and taps are used interchangeably depending on the machining method and the characteristics of the tools. Key points to ... 詳細表示

thread mill is engraved with INT. Wh...

INT stands for INTERNAL, which means for internal thread processing. 詳細表示

When machining tapered threads for pi...

For pipe screws of the same type, both external thread and internal threads can be shared as long as they are tapered. Combinations (1) Pipe tapered extern... 詳細表示

Tool selection for thread mills (PT, ...

OSG's program creation tool for thread mills "ThreadPro" can be used to create everything from tool selection to programming. It greatly reduces the time and... 詳細表示

TM3SC 28C36-144-3U of the single-poin...

BIG DAISHOWA OCA32-28 (Straight Collet with Oil Hole) The hydraulic chuck type holder that corresponds to the shank diameter Φ28 is a "hydro chuck". BBT40... 詳細表示

How to machine tapered threads that a...

In the instructions of the drawing, there are situations where it is difficult to process with standard Tap as follows. "The screwing length indication is e... 詳細表示

I am machining RC internal thread , b...

The direction of the insert attached to the holder may be reversed. Make sure the insert surface is "R" instead of "L". Holders with "LH" at the end of the... 詳細表示