What is helical machining?

What is helical machining? Helical machining refers to processing that uses planetary motion by the X, Y, and Z three-axis simultaneous control function... 詳細表示

When using the FX-ZDS end mill for ca...

Not required for FX-ZDS. For VP-ZDS in powder metallurgy HSS , Pilot hole is required. ( Pilot hole diameter is recommended to be at least 50% of the diamete... 詳細表示

Cutting conditions of long flutes

The cutting‑condition table for the EDL is not included in the catalog, but the feed and spindle speed should be adjusted according to the tool overhang, bas... 詳細表示

What is step cutting, end milling, de...

For example, in the case of deep side milling, it takes a very long overhang length to process. The long overhang makes it easier for the tool to deflect du... 詳細表示

counterboring Do you need Pilot hole...

If the machining environment (workpiece shape, machine, etc.) is sufficiently rigid, consider counterboring machining from a state where there is no Pilot ho... 詳細表示

Cutting conditions for end mills and ...

For milling and indexable tools, the following three numbers are required: (1) Revolution (min-1) How many revolutions per minute . In NC code, it is ex... 詳細表示

Can the plunging at the end mill be e...

In a typical end mill, it is not possible to process the bottom surface flat only with plunging . The reason is that the end cutting edge is not flat. If y... 詳細表示

How to calculate cutting conditions d...

How to calculate cutting conditions during helical machining Revolution, feed rate, distance traveled in the Z-axis direction per helical lap Learn how to c... 詳細表示

How to machine right-angle shapes wit...

In order to machine a right-angle shape with an end mill, the tool side that processes it must also have a right-angle shape when rotated. The shape of the t... 詳細表示

What are the effective measures again...

The causes and countermeasures for chattering are summarized below. Chattering Fast cutting speed Reducing the revolution. Resonance Change the re... 詳細表示