What are the effective measures again...

The causes and countermeasures for vibration are summarized below. Vibration Fast cutting speed Reducing the speed of rotation. Resonance Change t... 詳細表示

Cutting conditions for end mills and ...

For milling and indexable tools, the following three numbers are required: (1) Rotation speed (min-1) How many revolutions per minute . In NC code, it i... 詳細表示

How to machine right-angle shapes wit...

How to machine right-angle shapes with an end mill? Sharp Corner Edge Gaze In order to machine a right-angle shape with an end mill, the tool side that ... 詳細表示

How to calculate cutting conditions d...

How to calculate cutting conditions during helical machining Rotation speed, feed rate, distance traveled in the Z-axis direction per helical lap Learn how ... 詳細表示

counterboring Do you need Pilot hole...

If the machining environment (workpiece shape, machine, etc.) is sufficiently rigid, consider counterboring machining from a state where there is no Pilot ho... 詳細表示

How much processing conditions should...

The longer the amount of protrusion relative to the diameter of the tool, the more vibration and deflection will occur during machining. By lowering the cond... 詳細表示

Cutting conditions of long flutes

The EDL cutting conditions table is not listed in the catalog, but the feed and rotation are adjusted according to the amount of protrusion based on the cutt... 詳細表示

What is step cutting, end milling, de...

For example, in the case of deep side milling, it takes a very long overhang length to process. The long overhang makes it easier for the tool to deflect du... 詳細表示

What is helical machining?

What is helical machining? Helical machining refers to processing that uses planetary motion by the X, Y, and Z three-axis simultaneous control function... 詳細表示

Can the plunging at the end mill be e...

Can the plunging at the end mill be enough to flatten the bottom? In a typical end mill, it is not possible to process the bottom surface flat only with plu... 詳細表示