Whether or not HY-HSCM-P can be regri...

The regrinding of the HY-HSCM-P is possible. * The total length changes because the cutting edge is cut. 詳細表示

What is an end mill with a nick End m...

What is an end mill with nick (end mill end mill for semi-roughing ) An end mill with a nick is an end mill with a nick in the middle of the flute of a ... 詳細表示

What is a tapered end mill?

A cone-shaped peripheral flute end mill is called a tapered end mill. Peripheral flute Shape Square End Mill Tapered End Mill 詳細表示

What is HY-HSCM-P?

Multiple flutes Carbide end mill HY-HSCM-P is capable of high-efficiency machining that of conventional two-flute end mills, which is about three times more ... 詳細表示

Coarse pitch and Fine Pitch < Roughi...

coarse pitch and Fine Pitch < Roughing End Mills> The pitch of the nick groove (or R groove) is coarse pitch standard, and the fine pitch is fine. Wa... 詳細表示

What is a ball end mill?

A ball is one that has a spherical shape on the entire base. The number after R represents the ball radius. For example, R5 indicates a spherical shape with... 詳細表示

Can grooving be done with multiple f...

A typical four-flute end mill is not recommended for grooving where chip pockets are narrow and a large amount of chips need to be ejected. The two-flute en... 詳細表示

Is it possible to regrinding an end m...

Both AM-EBT (ball) and AM-CRE (radius) are regrinding possible. Recoating is also recommended to ensure performance. If you are considering regrindin... 詳細表示

Tools for processing ceramics

Tools for processing ceramics If the state of the ceramics is semi-sintered, try using a diamond-coated tool. For sintered ceramics, choose the electrodepo... 詳細表示

What is a keyway end mill?

Since there is a "keyway standard" defined by JIS for keyways, it is recommended that you check the width and depth of the keyway before machining before sel... 詳細表示