Coarse pitch and Fine Pitch < Roughi...
coarse pitch and Fine Pitch < Roughing End Mills> The pitch of the nick groove (or R groove) is coarse pitch standard, and the fine pitch is fine. Wa... 詳細表示
A ball is one that has a spherical shape on the entire base. The number after R represents the ball radius. For example, R5 indicates a spherical shape with... 詳細表示
Since there is a "keyway standard" defined by JIS for keyways, it is recommended that you check the width and depth of the keyway before machining before sel... 詳細表示
Do you have an end mill for bottom fi...
If you are looking for bottom surface roughness, we recommend the dedicated bottom finishing end mill “FX-MCF.” This is a dedicated end mill for bottom fini... 詳細表示
What are additive manufacturing end m...
What are additive manufacturing end mills AM-EBT AND AM-CRE? This is a tool for milling the surface layer in additive manufacturing (= metal additive manufa... 詳細表示
When the corner of an end mill is sharp (angled), it is referred to as a square end mill. End mill tip shapes (R indicates the radius) Square Ball Corn... 詳細表示
HY-QCC is a carbide Q-ball end mill with a spherical cutting edge. The cutting edge has a wide range of 282°, and the neck diameter is thinner than the ... 詳細表示
End mills with a flat end cutting edge
For end mills with a flat end cutting edge, the tool selection depends on the application. Application (1) Counterboring Machining ・ Counterboring En... 詳細表示
Whether or not HY-HSCM-P can be regri...
The regrinding of the HY-HSCM-P is possible. * The total length changes because the cutting edge is cut. 詳細表示
This is a carbide end mill dedicated to 45° back chamfering. In general, "right-hand cut, right-hand helix" front/back tools tend to be "negative cutting"... 詳細表示
Results:23 ,Showing: 11 - 20