What is a screw in MT6×0.75 grease ni...

MT6×0.75 screws and grease nipples are external thread standard. (JIS B 1575) external thread is 1/16 taper, but internal thread is a parallel thread and can... 詳細表示

What is Machine Tap?

It is important to note that there are various interpretations of the expression "machine tap". In Japan, there are many cases where it is one of the foll... 詳細表示

Differences in tap materials (SKS and...

Both refer to the base material used for tapping. SKS is an alloy tool steel. ・HSS is called high-speed tool steel. The main difference between the two... 詳細表示

What is BA Thread?

BA thread refers to the type of thread called BA in the British Standard BS, and the thread angle is 47.5 degrees. For example, if size is "2BA", then 2 r... 詳細表示

Tap processing of titanium 2 types (...

Tap processing of titanium 2 types (TB340) Two types of titanium (TB340) are pure titanium without heat treatment, and we recommend the Tap "EX-SUS-SFT... 詳細表示

What is a interrupted -shaped tap?

A interrupted -shaped tap is a type of tap for tapered threads, in which the thread of the complete tap thread is removed so that it jumps into a single thre... 詳細表示

Ichirinbuto

Ichirin (一厘) is the unit used to represent size in inches. 1 inch = 25.4 mm 1 minute (ichibu) = 1/8 inch = 3.175 mm Ichirin (一厘) = 1/10 of 1 minute ... 詳細表示

SKS Taps What are tungsten taps?

SKS is an alloy tool steel, commonly known as tungsten. On the packaging box, it is labeled "HIGH QUALITY TAPS". No Product Name Chamfer Size No ... 詳細表示

trapezoidal screw tap ACT <special tap>

This is a tap that can be screwed accurately and easily with trapezoidal screws, and is usually finished with a single raised tap after rough threading, o... 詳細表示

Tool selection based on HRC hardness

Tool selection based on HRC hardness When the material to be machined is not listed in the corresponding material column of the catalog, or when the propert... 詳細表示