What is the difference between New Ro...

New Roll Tap (NRT) and High Roll Tap (HRT) are both forming tap While HRT is a rolled-finish tap with basic performance and is limited to sizes of M6 or les... 詳細表示

Tapping into resin What kind of tap i...

Since there are various types of resins, different taps are suitable for different properties. Thermoplastic resins: Acrylic, vinyl chloride (PVC), etc. To... 詳細表示

Oversized taps for hot-dip galvanizing

Hot-dip galvanizing is also known as dobu plating. Due to the thick plating coating thickness , we do not have a stock product in our company. Depending on t... 詳細表示

Is the external center missing on spi...

Normally, spiral‑fluted taps of M6 or smaller have a protruding “external center” at the tip. 詳細表示

Is it possible to share a tap with UN...

0.5625-18UNJF is the inch notation of 9/16-18UNJF. Even with 9/16-18UNF taps, the shape of the internal thread is the same, so if the accuracy is correct, m... 詳細表示

trapezoidal screw tap ACT <special tap>

This is a tap that can be screwed accurately and easily with trapezoidal screws, and is usually finished with a single raised tap after rough threading, or a... 詳細表示

Tap processing for Hastelloy C22 and...

For Tap processing of Hastelloy C22 and C276, A-SFT and EX-SUS-SFT are recommended if they have been settled. As a guideline for cutting conditions, adjust t... 詳細表示

What is Synchro Tap? What kind of tap?

A synchro tap is a tap dedicated to a machine (also called synchronous, rigid, or direct) equipped with a complete lead feed mechanism that can accurately se... 詳細表示

What is a screw in MT6×0.75 grease ni...

What is the MT6×0.75 thread standard? The MT6×0.75 thread is a standard used for the male threads of grease nipples, defined by JIS B 1575. What is the d... 詳細表示

What is forming tap ?

Forming tap is a tap that processes threads by plastically deforming the minor diameter of the pilot holes. Since the threads are machined without cutting, t... 詳細表示