Does the finish of the thread mill be...

Since the thread mill is a cantilever tool, it may collapse or deflection due to the load during machining. Due to the deflection, the finish of the screw ma... 詳細表示

A thread mill with an exchangeable cu...

Make sure that the insert is not upside down. For tapered screws for pipes, there is a tapered on the insert side. Therefore, if the insert is installed on... 詳細表示

I would like you to fax the program o...

We do not contact you by fax for the program. You can create a program with ThreadPro, a program creation tool. 詳細表示

Tapered threading for pipes in a thre...

In the internal thread processing of tapered threads for pipes with a thread mill, it is effective to adjust the tool diameter correction in order to aim for... 詳細表示

Is it possible to regrinding a solid ...

Since there are multiple types of solid types, it is difficult to judge whether it is possible or not depending on its specifications, diameter, and degree o... 詳細表示

I want the movement of the thread mil...

When using ThreadPro, an NC program creation tool for thread mills, you can do the following. In the case of right-hand thread... For right-handed (right... 詳細表示

What is the minimum amount of room fo...

It is preferable to secure a margin of at least 1.5P for the threadmill Pilot hole , including the margin, but if it is confirmed that the risk of tool inter... 詳細表示

The actual thread mill is engraved wi...

It indicates the lead of the twisted flute. “Lead” refers to the linear distance of one full revolution of the spiral. 詳細表示

Are there any solid type (non- chip i...

All solid types such as AT-1 and WX-PNC are for internal thread machining. chip There is an interchangeable type for external thread machining chip . P... 詳細表示

I want to pass with a screw gauge . W...

If you select "Cutting Edge Reference" when creating a program with ThreadPro, a program creation app for thread mills, you can create an adjustable program ... 詳細表示