When machining tapered threads for pi...

When machining tapered threads for pipes with a thread mill, can the tools be shared with external thread internal threads? For pipe screws of the same type... 詳細表示

How to machine tapered threads that a...

In the instructions of the drawing, there are situations where it is difficult to process with standard Tap as follows. "The screwing length indication is e... 詳細表示

I want the movement of the thread mil...

When using ThreadPro, an NC program creation tool for thread mills, you can do the following. In the case of right-hand thread... For right-handed (right... 詳細表示

The size and pitch of the thread I wa...

The size and pitch of the thread I want to machine are not displayed. If the thread type is M (meter) and you cannot select the size and pitch of the thre... 詳細表示

I don't know which thread mill to use...

We recommend ThreadPro, an NC program creation software dedicated to thread mills. By entering the screw you want to process, a list of tools that can be pr... 詳細表示

I would like you to fax the program o...

We do not contact you by fax for the program. You can create a program with ThreadPro, a program creation tool. 詳細表示

Tool selection for thread mills (PT, ...

Tool selection for thread mill Pipe screws (PT, PS, Rc, Rp, R, G, PF, NPT, NPTF) OSG's program creation tool for thread mills "ThreadPro" can be used to cre... 詳細表示

A thread mill with an exchangeable cu...

Make sure that the insert is not upside down. For tapered screws for pipes, there is a tapered on the insert side. Therefore, if the insert is installed on... 詳細表示

I am machining RC internal thread , b...

The direction of the insert attached to the holder may be reversed. Make sure the insert surface is "R" instead of "L". Holders with "LH" at the end of the... 詳細表示

Are there any solid type (non- chip i...

All solid types such as AT-1 and WX-PNC are for internal thread machining. chip There is an interchangeable type for external thread machining chip . P... 詳細表示