The actual thread mill is engraved wi...

It indicates the lead of the twisted flute. “Lead” refers to the linear distance of one full revolution of the spiral. 詳細表示

Can the holder for tapered threads (T...

Can the holder for tapered threads (TMNC) for pipes also process parallel threads? It's possible. On the other hand, even if the standard type TMC holder... 詳細表示

Tapered threading for pipes in a thre...

Tapered threading for pipes in a thread mill How to adjust to pass the gauge In the internal thread processing of tapered threads for pipes with a thread ... 詳細表示

chip Can the inserts of the intercha...

chip Can the inserts of the interchangeable thread mill be used on both sides by interchanging the front and back? In the case of parallel screws (M, U, G... 詳細表示

When machining tapered threads for pi...

When machining tapered threads for pipes with a thread mill, can the tools be shared with external thread internal threads? For pipe screws of the same type... 詳細表示

What is the minimum amount of room fo...

It is preferable to secure a margin of at least 1.5P for the threadmill Pilot hole , including the margin, but if it is confirmed that the risk of tool inter... 詳細表示

Is there an interchangeable thread mi...

Is there a chip interchangeable thread mill that can process tapered threads for PT1/8 and PT1/4 pipes? Indexable type ( chip interchangeable) thread mill... 詳細表示

threadmill is engraved with INT. Wha...

threadmill is engraved with INT. What does this mean? INT stands for INTERNAL, which means for internal thread processing. 詳細表示

TM3SC 28C36-144-3U of the single-poin...

BIG DAISHOWAOCA32-28 (Straight Collet with Oil Hole) The hydraulic chuck type holder that corresponds to the shank diameter Φ28 is a "hydro chuck". ... 詳細表示

I am machining RC internal thread , b...

The direction of the insert attached to the holder may be reversed. Make sure the insert surface is "R" instead of "L". Holders with "LH" at the end of the... 詳細表示