Do you have an end mill for bottom fi...

If you are looking for bottom surface roughness, we recommend the dedicated bottom finishing end mill “FX-MCF.” This is a dedicated end mill for bottom fini... 詳細表示

What is a Square End Mill?

When the corner of an end mill is sharp (angled), it is referred to as a square end mill. End mill tip shapes (R indicates the radius) Square Ball Corn... 詳細表示

What is a keyway end mill?

Since there is a "keyway standard" defined by JIS for keyways, it is recommended that you check the width and depth of the keyway before machining before sel... 詳細表示

What is a Slotting End Mill?

Straight‑flute molding end mills are sometimes referred to as slotting tools. (The helix angle of the flute is 0°.) There are applications that are assumed ... 詳細表示

Can grooving be done with multiple f...

A typical four-flute end mill is not recommended for grooving where chip pockets are narrow and a large amount of chips need to be ejected. The two-flute en... 詳細表示

What is a tapered end mill?

A cone-shaped peripheral flute end mill is called a tapered end mill. Peripheral flute Shape Square End Mill Tapered End Mill 詳細表示

Tools for processing ceramics

Tools for processing ceramics If the state of the ceramics is semi-sintered, try using a diamond-coated tool. For sintered ceramics, choose the electrodepo... 詳細表示

What are OH1 and OL1? What is the flu...

In OSG end mills, the symbols "OH~" and "OL~" indicate the end mill diameter tolerance. * The ~ part of "OH~" and "OL~" contains a number to indicate the de... 詳細表示

What is a ball end mill?

A ball is one that has a spherical shape on the entire base. The number after R represents the ball radius. For example, R5 indicates a spherical shape with... 詳細表示

Cutting conditions of long flutes

The cutting‑condition table for the EDL is not included in the catalog, but the feed and spindle speed should be adjusted according to the tool overhang, bas... 詳細表示