What are OH1 and OL1? What is the flu...
In OSG end mills, the symbols "OH~" and "OL~" indicate the end mill diameter tolerance. * The ~ part of "OH~" and "OL~" contains a number to indicate the de... 詳細表示
When using the FX-ZDS end mill for ca...
Not required for FX-ZDS. For VP-ZDS in powder metallurgy HSS , Pilot hole is required. ( Pilot hole diameter is recommended to be at least 50% of the diamete... 詳細表示
What is an end mill for V-groove mach...
What is an end mill for V-groove machining? Currently, we do not have any solid tools that we recommend for V-groove machining. There are tools with a V-sh... 詳細表示
Since there is a "keyway standard" defined by JIS for keyways, it is recommended that you check the width and depth of the keyway before machining before sel... 詳細表示
What are additive manufacturing end m...
What are additive manufacturing end mills AM-EBT AND AM-CRE? This is a tool for milling the surface layer in additive manufacturing (= metal additive manufa... 詳細表示
What is the difference between 2 and ...
How to use an end mill with 2 flutes or 4 flutes? In general, slotting and drilling are difficult to discharge chips, and other processes that require a... 詳細表示
What is Slotting End Mill? What is STDN? straight flute Molding end mills are sometimes referred to as slotting. (The twist angle of the groove is 0°) ... 詳細表示
Can grooving be done with multiple f...
A typical four-flute end mill is not recommended for grooving where chip pockets are narrow and a large amount of chips need to be ejected. The two-flute en... 詳細表示
Tools for processing ceramics If the state of the ceramics is semi-sintered, try using a diamond-coated tool. For sintered ceramics, choose the electrodepo... 詳細表示
Results:39 ,Showing: 31 - 39