How much processing conditions should...
The greater the tool overhang relative to its diameter, the more chattering and deflection will occur during machining.By reducing the cutting conditions, th... 詳細表示
How to machine right-angle shapes wit...
In order to machine a right-angle shape with an end mill, the tool side that processes it must also have a right-angle shape when rotated. The shape of the t... 詳細表示
Since there is a "keyway standard" defined by JIS for keyways, it is recommended that you check the width and depth of the keyway before machining before sel... 詳細表示
What is a roughing end mill (end mill...
It is an end mill with a wavy cutting edge with a peripheral flute connected to the R (hemisphere) and is designed to reduce cutting force. The machined sur... 詳細表示
counterboring Do you need Pilot hole...
If the machining environment (workpiece shape, machine, etc.) is sufficiently rigid, consider counterboring machining from a state where there is no Pilot ho... 詳細表示
HY-QCC is a carbide Q-ball end mill with a spherical cutting edge. The cutting edge has a wide range of 282°, and the neck diameter is thinner than the ... 詳細表示
Can grooving be done with multiple f...
A typical four-flute end mill is not recommended for grooving where chip pockets are narrow and a large amount of chips need to be ejected. The two-flute en... 詳細表示
Do you have an end mill for bottom fi...
If you are looking for bottom surface roughness, we recommend the dedicated bottom finishing end mill “FX-MCF.” This is a dedicated end mill for bottom fini... 詳細表示
Can the plunging at the end mill be e...
In a typical end mill, it is not possible to process the bottom surface flat only with plunging . The reason is that the end cutting edge is not flat. If y... 詳細表示
End mills with a flat end cutting edge
For end mills with a flat end cutting edge, the tool selection depends on the application. Application (1) Counterboring Machining ・ Counterboring En... 詳細表示
Results:39 ,Showing: 21 - 30